6.9.14 ETR 290 - Service thresh.
The Service thresholds make it possible to define detailed conditions for alarm
triggering on a per-service basis. There is one predefined service threshold template
that cannot be edited by the operator: Default. The Default service threshold
template contains no service definitions and therefore will never trigger any alarms.
By associating scheduling templates to service threshold templates it is possible to
disable alarming at pre-selected time intervals. Scheduling templates are defined in
the Setup - Scheduling view and will be available from the schedule drop-down
menu.
In the 'Service Thresholds' table, the 'Refs' column shows how many streams are
associated with each threshold template.
There are two different ways of creating user-defined thresholds. To create a new
threshold template from scratch the operator should click the Add new threshold
button. A pop-up window will appear allowing the user to define alarm conditions.
Another way of creating a user-defined threshold template is by highlighting one of the
templates already defined and then click the Duplicate highlighted button.
Deleting a service threshold template is done by highlighting the template that should
be removed and clicking Delete highlighted. Note that if the deleted threshold
template was assigned to a stream being monitored, the new threshold template for
that stream will default to the Default template.
PROBE USERS' MANUAL VERSION 5.0
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
www.bridgetech.tv
157
To Next Page
Loading...