Brother BAS-705 - Setting the Program Number

1. Press the MODE switch w to select AUTO mode.
2. While pressing the SELECT switche e , press
the MODE switch w.
*
This will change the mode to ADJUSTMENT mode.
3. Use the ▲ and ▼ SELECT switches e to move the
pointer "◆ " so that "X-Y/program" is selected,
and then press the ENTER switch t.
4. Use the ▲ and ▼ SELECT switches e again to
move the pointer " ◆ " so that "Program No." is
selected.
5. While using the SELECT switch e to move the
cursor "-" , press the ▲ and▼SELECT switches e
to set the desired program number.
* If the CANCEL switch e is pressed, the old previ
ously-set program number will appear again on
the display.
6. Press the ENTER switch t.
* The new program number setting will appear on
the display.
* At this time, the feed mechanism, will move to
the sewing start position.
3. PANEL OPERATION
3-2-6. Setting the program number
・ This procedure is used to set the program number for a sewing pattern.
・ The standard sewing patterns are 1 (29 stitches), 2 (36 stitches) and 3 (43 stitches).
▲
▲
AUTO MODE
Production counter
◆ 1st bobbin counter
2nd bobbin counter
ADJUSTMENT(/)
Loop/feed
◆ X-Y/program
X-Y/test feed
X-Y/PROGRAM/(ADJ)
◆ Program No. x
X scale (%)
Y scale (%)
X-Y/PROGRAM/(ADJ)
◆ Program No. z
X scale (%)
Y scale (%)
― 18 ―
BAS-705
選択
SELECT
モード
MODE
確定
ENTER
リセット
RESET
電源
POWER
取り消し
CANCEL
警告
WARNING
BAS-705

r
te
w