4. SEWING
4. SEWING
1. To install the needle q for the first bar tacking, loosen the set screw w, insert the needle q as far as it will go
so that the long groove is facing toward you (side A), and then tighten the set screw w.
2. To install the needle e for the second bar tacking, loosen the set screw r, insert the needle e as far as it will
go so that the groove is facing away from you (side A), and then tighten the set screw r.
CAUTION
・ Turn off the power switch before installing the needle, otherwise the machine may operate of the
start switch is depressed by mistake and serious injury could result.
4-1. Replacing needle
― 24 ―
BAS-705
q
w
r
e
A
To Next Page
Loading...
