Brother BAS-705 - Page 60

6. STANDARD ADJUSTMENT (MECHANISMS)
―57―
BAS-705
w
e
q
t
r
r
q
w
uy
[When replacing the fork bracket (separate type)]
1. Loosen the two set screws w of the fork bracket
shaft q, and then remove the fork bracket e from
the fork bracket shaft q.
2. Insert the new fork bracket r onto the fork bracket
shaft q until the end of the fork bracket r is
aligned with the end of the loop presser t, and then
tighten the two set screws w.
■ When replacing fork shaft L and fork shaft S
Loosen the set screw y and then replace for shaft
L and fork shaft S u.