5-56
Confidential
1.3.27 Customize Code Destinations (Maintenance mode 74)
<Function>
This procedure customizes the machine according to settings of the language, functions, and worker
switches.
<Operating Procedure>
(1) Press the [7] and [4] keys in this order in the initial stage of the maintenance mode.
The machine displays "Select 74?" on the LCD.
(2) Press the [Mono Start] key.
The machine displays current settings on the LCD.
(3) Enter the desired customizing code.
(4) Press the [Mono Start] key.
This saves the new setting and returns the machine to the initial stage of the maintenance mode.
If the destination code is changed, "PLS UPDATE PROG" appears on the LCD. Load the latest
firmware (refer to Chapter 4, Section 1.3).
(5) Pressing the [Stop] key during the above procedure returns the machine to the initial stage of
the maintenance mode without saving the customizing code.
Note If no keys are pressed for at least one minute with any display state, the machine automatically
returns to the initial stage of the maintenance mode.
■ EEPROM customizing codes list
US Canada Germany/Austria UK/Ireland
DCP-J552DW - - 0004 0004
DCP-J752DW - - 0104 0104
MFC-J285DW 0001 0002 - -
MFC-J450DW 0201 0202 - -
MFC-J470DW 0001 0002 0003 0004
MFC-J475DW 0101 0102 - -
MFC-J650DW 0001 0002 0003 0004
MFC-J870DW 0001 0002 0003 0004
MFC-J875DW 0101 0102 - -