2-15
Confidential
3.3 Communications Error
Code 1 Code 2 Cause
Reference
Page
10 07 No paper when document transmission is called. Section
4.9.3 "A
communicat
ions error
occurs"
10 08 Wrong fax number sent.
11 01 No dial tone detected before start of dialing.
11 02 Busy tone detected before dialing.
11 03 2nd dial tone not detected.
11 05 Loop current cannot be detected.
11 06 Busy tone was detected after dialing or after the incoming call.
11 07 No response from the receiver during sending.
11 10 A tone cannot be detected after dialing.
11 11 No response after sending Fax2 net command.
13 12
NG response signal was received after sending Fax2 net
command.
16 09 The encryption key is not registered.
17 07 There is no response from the receiver upon signal receipt.
20 01 Unable to detect a flag field.
20 02 Carrier interruption lasted for 200 msec.
20 03
An interrupt command (continuous "1" for 7 bits or more) was
detected.
20 04 An overrun was detected.
20 05 A 3-second or more frame was received.
20 06 A CRC error occurred during answer back.
20 07 An echo command was received.
20 08 An invalid command was received.
20 09
A command was ignored once for document setting or for
dumping-out at turn-around transmission.
20 0A A T5 timeout error occurred.
20 0B CRP was received.
20 0C EOR and NULL were received.
20 0D
No corresponding command was received even though the FIF
Command send bit is ON.
20 0E EORCommand was received.
32 01
The remote terminal only supports 2400 bps or 4800 bps V.29
specifications.
32 02 The remote terminal is not ready to receive polling.
32 10
The remote terminal does not have a password function, or the
password function is turned OFF.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
