4-4
Confidential
■ Installing the firmware using computer
<Operating procedure>
(1) If the computer and machine are connected with an USB cable, disconnect the USB cable
an
d enter the maintenance mode. (Refer to “1.1 How to Enter the Maintenance Mode”
in
Chap
ter 5.)
(2) Connect the computer to the machine with the USB cable.
(3) Open the temporary folder, double-click the “Filedg32.exe” to start, and select “Brother
Maintenance USB Printer”.
(4) Drag and drop a necessary program file (for instance, LZXXXX_$.djf)
located in the same
fo
lder to the Brother Maintenance USB Printer icon located within the FILEDG32 screen.
The files are sent to the machine and installation into the flash ROM is started.
(5) When installation is completed, the machine reboots and returns to the ready state.
(6) Turn OFF the power of the machine, and repeat steps (1) to (5) to install necessar
y
firmwa
re.
(7) Turn OFF the power of the machine, and disconnect the USB cable.
1.2 Initializing the EEPROM of the Main PCB ASSY
(Function code 01)
Initialize the EEPROM of the main PCB ASSY in accordance with “1.3.1 EEPROM parameter
initialization (Function code 01, 91)” in Chapter 5.
Memo:
- Install the Sub firmware, Panel firmware, Main firmware, and High-voltage firmware in this
order.
- Never disconnect the AC cord of the machine or computer, or the USB cable duri
ng
inst
alling.
- If you failed to install the firmware, turn OFF the power of the machine and turn
it ON
again. The machine automatically
enters the firmware installing mode. Perform
the
following inst
alling procedures again.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
