5-32
Confidential
■ Change of the transfer current setting (Only for Japanese hagaki printing)
<Function>
Dots appeared when hagaki printing is performed can be alleviated by changing the transfer
current setting.
<Operating procedure>
(1) Press the 4 and 5 keys in this order in the initial state of the maintenance mode. “USBNo.”
is displayed on the LCD.
(2) Press the or key to display “Special Printing” and then press the Mono Start or
SET key. “Default” is displayed on the LCD.
(3) Press the or key to change the setting, and press the Mono Start or SET key.
There are four setting options: “Default”, “HAGAKI1”, “HAGAKI2”, and “HAGAKI3”. (“*” is
displayed at the end of the currently specified function in the LCD display. The initial value
is “Default”.)
(4) “Accepted” is displayed on the LCD, and the machine returns to the initial state of the
maintenance mode.
(5) Perform hagaki printing again to check if the dot symptom is alleviated.
(6) If not, repeat the steps (1) to (4) to set an optimum option, and then perform hagaki
printing.
■ Change of ghost reduction setting
<Function>
This function is a mode to reduce the level of ghost when it appears in low temperature and
high humidity environment. If this function is turned ON, however, spots and dirt may appear
on print.
“*” is displayed at the end of the currently specified function in the LCD display.
<Operating procedure>
(1) Press the 4 and 5 keys in this order in the initial state of the maintenance mode. “USBNo.”
is displayed on the LCD.
(2) Press the or key to display “Ghost Reduction” and then press the Mono Start or
SET key.
(3) Press the or key to select “ON” or “OFF”, and press the Mono Start or SET key.
(4) “Accepted” is displayed on the LCD, and the machine returns to the initial state of the
maintenance mode.
LCD Description
ON Turn ON the ghost reduction function.
OFF Turn OFF the ghost reduction function. (default)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
