203
POWERHEAD
POWERHEAD DISASSEMBLY
10
Remove the lower main bearing only if it needs to
be replaced. Use external retaining ring pliers to
remove the lower bearing retaining ring.
IMPORTANT: If the lower main bearing is
removed from the crankshaft, it must be dis-
carded. DO NOT reuse it.
Use a bearing separator to support the bearing,
and press off the crankshaft.
Remove and inspect crankcase seal rings. Iden-
tify each ring for installation in original location.
Remove center main bearings and split sleeves
for inspection. Do not mix parts. Note location of
bearings for reassembly.
24384
24383
49069
24381
To Next Page
Loading...
