Safety
H148850_3_003 11
3 Safety
Review this product and related documentation to become familiar with safety markings and
instructions before you operate the device.
3.1 Safety Notices
CAUTION
Injury Hazard
If the device is used in a manner not specified by the manufacturer, the protection provided
by the device may be impaired.
Any retrofitting, repairs or dismantling of the device must only be carried out by Bruker
Service or personnel authorized by Bruker.
Damage due to servicing that is not authorized by Bruker is not covered by your warranty.
3.1.1 Power Cord Set Requirements
The power cord set supplied with the device meets the requirements of the country where the
device was purchased. Power is supplied to the device through the included 24V power
supply.
3.1.2 Power Cord Safety Maintenance
The operator should check the condition of the power/signal supply cord. The device should
not be operated if the mains inlet is cracked or broken. Any obvious damage to the case
(from a drop or fall) should be checked by service personnel for loose or damaged parts.
Refer to the individual part lists, or contact Bruker, for approved replacement parts.
3.1.3 Mains Disconnect
The power switch on the rear panel is not the mains disconnect. Power mains disconnect is
accomplished by unplugging the power cord from the power supply or from the wall outlet.
Ensure the power cord is easily accessible and removable, in the event of an emergency
which requires immediate disconnection.
To Next Page
Loading...
