Bruker minispec User Manual

List of Figures
H148850_3_003
75
List of Figures
Figure 3.1: Overview of the Mechanical Hazards (Without Optional Safety Barrier) ...................... 13
Figure 3.2: Overview of the Mechanical Hazards (With Optional Safety Barrier) ........................... 13
Figure 3.3: E-Stop Button ............................................................................................................... 15
Figure 4.1: Sample Automation XYZ Sample Changer—Front View with TC3 (10 mm SFC Ver-
sion), TC6 and MFC Analyzer ...................................................................................... 17
Figure 4.2: Sample Automation XYZ Sample Changer—Front View with TC3 (2 Zone 26 mm
Version) and Sample Stage.......................................................................................... 18
Figure 4.3: Sample Automation XYZ Sample Changer—Back View of Sample Changer Head. ... 19
Figure 4.4: TC3 and TC6 Temperature Units. ................................................................................ 20
Figure 6.1: Mounting Bracket.......................................................................................................... 25
Figure 6.2: E-Stop Shown on Left Side of the Base ....................................................................... 26
Figure 6.3: Location of Holes in the Bracket ................................................................................... 26
Figure 6.4: Location of Mounting Screws........................................................................................ 26
Figure 6.5: Rear View of E-Stop After Mounting (shown mounted to safety barrier so that screw
locations are more visible) ............................................................................................ 27
Figure 6.6: E-stop Connected to the Sample Changer ................................................................... 27
Figure 6.7: Message Showing that a Driver was not Found. .......................................................... 29
Figure 6.8: Choosing to Install USB Driver ..................................................................................... 29
Figure 6.9: Choosing to Install USB Driver from a Removable Media ............................................ 29
Figure 6.10: Searching for the Driver................................................................................................ 30
Figure 6.11: Selecting the Driver ...................................................................................................... 30
Figure 6.12: Driver Installation is Complete ...................................................................................... 30
Figure 8.1: E-Stop Button ............................................................................................................... 45
Figure 8.2: Safety Barrier Latch ...................................................................................................... 46
Figure 9.1: Sample Stage (10 mm Version Shown)........................................................................ 47
Figure 9.2: Opening on the Bottom of the Sample Stage. .............................................................. 49
Figure 9.3: Address Dial. ................................................................................................................ 49
Figure 9.4: Dual Sample Stage Addresses—26 mm. ..................................................................... 50
Figure 9.5: Dual Sample Stage Addresses—10 mm. ..................................................................... 50
Figure 9.6: Base of the Sample Changer........................................................................................ 51
Figure 9.7: Serial Connector on the Sample Stage ........................................................................ 52
Figure 9.8: Power Supply................................................................................................................ 52
Figure 9.9: Power Connections for the Sample Stage.................................................................... 53
Figure 10.1: Positioning the Carriage. .............................................................................................. 57
Figure 10.2: Sliding the Z-Drive onto the Y-Arm. .............................................................................. 58
Figure 10.3: Attaching the Z-Drive to the Carriage. .......................................................................... 58
Figure 10.4: Attaching the Z-Drive Strain Relief Block...................................................................... 59
Figure 10.5: Connecting the Z-Drive Cable ...................................................................................... 59
Figure 10.6: Connecting Tubing Tamer ............................................................................................ 60
Figure 10.7: Tubing Tamer Properly Installed on Z-Drive Cable ...................................................... 60

Bruker minispec Specifications

General

Brand	Bruker
Model	minispec
Category	Laboratory Equipment
Language	English