Introduction
H148850_3_003 9
2 Introduction
The Sample Automation XYZ sample changer is designed to be sturdy, reliable, and easy to
use. It provides automated temperature control and pick-and-place sample introduction for an
analytical instrument such as an NMR spectrometer. The sample changer contains a
microprocessor that allows sequential or random access to samples, providing flexibility.
The sample changer is typically interfaced to and controlled by the host computer using a
USB or serial connection.
This document describes the procedures for installing, operating, and maintaining the sample
changer. It also provides information about troubleshooting minor problems and describes the
design of the sample changer.
2.1 Overview
2.1.1 Who Should Read This Book
The primary audience for this manual consists of analytical chemists and laboratory
technicians. To use this manual effectively, you should have a basic knowledge of chemistry,
a basic knowledge of electronic sampling equipment, at least a beginning level of computer
experience, and working knowledge of other equipment used with the device.
WARNING
Chemical Injury Hazard
Exposure to laboratory chemicals may result in serious injury.
u The device is intended for use only by qualified operators who have been trained in safe
laboratory practices. Make sure you know the hazards associated with all of the
chemicals you are using, and take the appropriate precautions.
2.2 Intended Use
The Sample Automation XYZ sample changer is designed for use as a temperature-
controlled, pick-and-place automation system in analytical laboratories performing chemical
analysis of samples.
2.3 Where to Go for More Information
For additional information on this and other products refer to the Bruker website:
www.bruker.com.
To Next Page
Loading...
