Bruker minispec - Table of Contents

Contents
H148850_3_003
iii
Contents
1 About This Manual .............................................................................................................................7
1.1 Policy Statement .................................................................................................................7
1.2 Symbols and Conventions ..................................................................................................7
2 Introduction.........................................................................................................................................9
2.1 Overview .............................................................................................................................9
2.1.1 Who Should Read This Book..............................................................................................9
2.2 Intended Use.......................................................................................................................9
2.3 Where to Go for More Information ......................................................................................9
3 Safety.................................................................................................................................................11
3.1 Safety Notices...................................................................................................................11
3.1.1 Power Cord Set Requirements .........................................................................................11
3.1.2 Power Cord Safety Maintenance ......................................................................................11
3.1.3 Mains Disconnect..............................................................................................................11
3.1.4 Operating Environment .....................................................................................................12
3.1.5 Mechanical Hazards .........................................................................................................13
3.1.6 Explanation of Caution and Warning Notices ...................................................................14
3.2 Electromagnetic Interference ............................................................................................14
3.3 Explanation of Regulatory Marks ......................................................................................15
3.4 Location of the Emergency Stop Button ...........................................................................15
4 Design and Function ........................................................................................................................17
4.1 Sample Changer Components..........................................................................................17
4.2 Additional Equipment Required ........................................................................................19
4.3 Optional Accessories ........................................................................................................20
4.4 Chemical Compatibility .....................................................................................................20
5 Transport, Packaging and Storage .................................................................................................21
6 Installation.........................................................................................................................................23
6.1 Preparing for Installation ...................................................................................................23
6.1.1 Choosing a Location .........................................................................................................23
6.1.1.1 Space Requirements ........................................................................................................24
6.1.1.2 Work Surface Requirements.............................................................................................24
6.1.1.3 Power Requirements ........................................................................................................24
6.2 Installing the Temperature Units .......................................................................................25
6.3 Mounting the NMR Instrument ..........................................................................................25
6.4 Connecting the E-Stop Button ..........................................................................................25
6.4.1 Without the Safety Barrier.................................................................................................26
6.4.2 With the Safety Barrier......................................................................................................27
6.5 Connecting the Sample Changer to the Power Supply.....................................................28
6.6 Connecting the Sample Changer to the Host Computer...................................................28
6.7 Establishing a USB Communications Interface ................................................................28
6.8 Establishing an RS-232 Serial Communications Interface ...............................................31
6.9 Verifying Installation..........................................................................................................31