EasyManuals Logo
Home>Bruker>Laboratory Equipment>minispec

Bruker minispec User Manual

Bruker minispec
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Transport, Packaging and Storage
H148850_3_003 21
5 Transport, Packaging and
Storage
WARNING
Lifting Hazard
Lifting without assistance may cause injury.
u Two people are required to lift the device.
u Lifting should be done with a person situated on either side of the device.
u Never attempt to lift or move the device when the temperature units and NMR
instrument are installed.
Upon receipt of the device, inspect external packaging for signs of shipping damage. Inspect
all items during unpacking and notify the carrier immediately of any concealed damage.
Check for any kinked tubing.
If the system is shipped or removed from storage during cold weather, allow the packaged
equipment to equilibrate to room temperature before opening and exposing to warm, humid
air. It is usually sufficient to provide four to eight hours for this purpose.
NOTICE
Material Damage from Condensation
Condensation that forms on or inside the device may cause equipment damage.
u Allow the device to dry thoroughly before connecting it to a power source and operating
it.
Remove the packing checklist from the shipping container, and check off items against it.
Leave accessories in the packaging until you are ready to install them.
Note: Keep the factory packaging for use in case the product ever needs to be returned or
shipped to another location.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bruker minispec and is the answer not in the manual?

Bruker minispec Specifications

General IconGeneral
BrandBruker
Modelminispec
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals