T419S Indicator Service Manual 17
3 Introduction to the menus
Menus, accessed through passwords, are available to customize and configure the
indicator for your purposes. The menu levels and their passwords are shown below:
Some menus appear in more than one menu level. As you can see in the table above,
the 111 password gives you access to three menus; User, About and Audit. The 3570
password gives you access to those three plus the Diagnostics menu. The 3088
password gives you access to those four plus the Setup menu.
This allows the supervisor to control access to some or all of the menus based on the
passwords shared. The menus are the same no matter which password is used.
3.1 Menu Navigation
Navigation through the menus is accomplished by using arrow, enter and escape keys.
Sometimes the F keys have these functions and they are shown on-screen. The TARE,
SELECT, ZERO, PRINT and UNITS keys also have navigation arrows and when both
are available either can be used. See Figure 3.1.
Figure 3.1 Navigation keys
3.2 Exiting a menu
To exit a menu you may first have to use the ESC softkey, if on the screen. When that
key is no longer available, use the up arrow softkey repeatedly until you are asked if
you want to save any changes made. Use the Up or Down key to make your choice
and press the ENTER key to accept. The indicator will reboot and return to the startup
screen with the new changes active.
Password Menu Level Accessed Menus
111 USER User, About, Audit (See User level menu on page 18)
3570 DIAGNOSTICS Diag, User, About, Audit (See Diagnostics menu on page 22)
3088 ADMIN Setup, Diag, User, About, Audit (See ADMIN Menu on page 26)
2580 CALIBRATE Calibration
The CALIBRATE menu level accesses the calibration procedure only. You can also
access the calibration menu through the Setup menu using the ADMIN password.
The menus are explained in a sequential manner to cover all information in a logical
fashion. You will probably never access all the menu items in this manner. You can
navigate to the area of the menu that needs to be changed by using the menu maps.
TAR E SELECT
ZERO
PRINT
UP DOWN ENTER LEFT RIGHT
UNITS
To Next Page
Loading...
Need help?
General
