T419S Indicator Service Manual 39
6.2 Scale menu
Option Pick this mode if you are using the analog scale option card.
Protcl Pick this mode if you are using the BSQ base connected to a
serial port or if you are using a ZB210. The ZB210 must be
configured fully through Ztools. For more information on the
ZB210 refer to the ZB210 Installation/Service manual, PN
AWT35-501806.
Bind This option appears in two different forms depending on which Mode you
pick. If you pick Disable or Onboard in the Mode menu, the Bind menu
does not appear.
If you choose Option, this selection requires a bus and card number. Up
to four option cards can be installed.
If you choose Protcl, you must choose a binding with a protocol selection.
There are 20 available protocols and the protocol number selected must
be matched with a properly configured protocol shown in Protcl on page
51.
To Next Page
Loading...
Need help?
General
