Burkert 8175 - 4.4 CALIBRATION MENU

26
8175
ENGLISH
CALIBRATION MENU
4.4 CALIBRATION MENU
PRESS SIMULTANEOUSLY FOR 5 SECONDS
The following parameters can be set within this menu: SECTIONS
The following sections explain how to change the parameter values within the
calibration menu above.
4.4.1
4.4.2
4.4.3
4.4.4
4.4.5
4.4.6
4.4.7
4.4.8
ENTER
Selection between English, German,
French, Italian or Spanish.
Selection of engineering units for level,
distance or volume.
Damping selection and delay time setting
for signal failure alarm. There are ten
different steps available.
(Range 0 to 9).
Gas characteristics (velocity of sound and
temperature influence).
Selection of the target level and if there are
any fixed echos to be filtered and
eliminated by the transmitter.
Manual or automatic determination of the
specific application parameters.
Setting of the 4-20mA output signal range.
Parameter definition of relays 1 & 2 for
level, distance or volume, T° and/or failure
alarm.
Back to the operation mode; store the new
parameters set.
0......9
UNIT
FILTER
ECHO
TEACH-IN
RELAY
END
LANGUAGE
GAS COMP
CURRENT
4.4