Burkert 8175 - Language; Engineering Units

27
8175
ENGLISH
CALIBRATION MENU
ENTER
ENTER
0......9
0......9
4.4.1 LANGUAGE
The selection of an alternative language is confirmed by the Enter-key and
becomes immediately active.
4.4.2 ENGINEERING UNITS
The selection of the units will depend on the application and the configuration of the
transmitter via level, distance or volume for fluid measurement.
● If the transmitter is to be configured to measure Level or Distance, select
the measuring units and decimal points as required.
● If volume is to be selected and configured it is important to note that the
transmitter display within the ‘VOLUME TEACH-IN‘ may not be the
measuring units selected. The conversion of units by the transmitter
only applies within the Volume Teach-In and the table below displays
the measuring units selected and the displayed units which will be used
within the Volume Teach-In.
SELECTED MEASURING UNITS UNITS USED FOR TEACH-IN
UNIT
DISTANCE/LEVEL VOLUME DISTANCE VOLUME
cm l m l
ml m l
cm m
3
mm
3
mm
3
mm
3
cm US/Imp gal NOT VALID
m US/Imp gal NOT VALID
inch l NOT VALID
foot l NOT VALID
inch m
3
ft m
3
foot m
3
ft m
3
inch US/Imp gal ft US/Imp gal
foot US/Imp gal ft US/Imp gal
LANGUAGE
4.4.1
ENGLISH
DEUTSCH
FRANCAIS
ITALIANO
ESPANOL