8630 - 77
OPERATION AND CONTROLLER FUNCTIONS
OUT ANL -
Standard signal for the analog position output
OUTPUT
(Option)
Configuration of the outputs
NOTE
The signal types shown in gray are only selectable with active process controller.
Configure the analog output
End of configuration of the outputs
Configure binary output 2
Configure binary output 1
Current 4..20 mA
Current 0..20 mA
Voltage 0..10 V
Voltage 0..5 V
Selection of the desired standard
signal
Actual position
Setpoint position
Actual value of process
Actual value of process
Selection of the desired output
To Next Page
Loading...
