GasAlertMicroClip
User Manual
46
5. When charging is complete, the charging indicator stops flashing
and displays to indicate a full charge. Remove the charging
adapter and activate the detector.
If the battery indicator does not display, refer to Troubleshooting
.
6. Charge the battery after each workday.
Note
To reach full battery capacity, allow the battery to fully charge and
fully discharge three times.
Charging the detector in temperatures above 113°F (45°C) will
greatly reduce the number of charges the detector can accept.
The detector may be warm immediately following charging. This
is normal.
Replacing a Sensor or Sensor Filter
a Warning
To avoid personal injury, only use sensors that are
specifically designed for the detector. Refer to Replacement
Parts and Accessories.
Use proper ESD handling practices.
• Each sensor has a high degree of resistance to common vapors and
gases. To clear a sensor, move the detector to a non-hazardous
environment and wait 10 to 30 minutes.
• Do not expose a sensor to vapors of inorganic solvents such as
fumes from paint thinners, or organic solvents such as benzoic acids
and acrylic acids.
• Ensure hands are clean or wear gloves before handling components.
To replace a sensor or sensor filter, refer to
•Table 1
4,
• Figure 11
,
• Figure 12
• Figure 1
3, and
• the following procedures.
To Next Page
Loading...
