BW Technologies GasAlertMicroClip XT - Reassembling the Detector

51
GasAlertMicroClip
User Manual
Reassembling the detector
1. To re-assemble the detector, perform the following:
• Verify the PCB is seated correctly and inserted exactly as it
was removed (sensors facing the front shell).
• Replace the two PCB screws.
• Visually inspect the battery to ensure no damage has occurred.
• When replacing the rear shell, ensure the charging pi
ns
(bo
ttom of inside rear shell) are aligned with the correspondin
g
ho
les on the PCB. If the contact pins are bent, the battery wil
l
n
ot charge correctly.
Note
Ensure the rib on the interior rear shell
inserts between the
battery and the PCB .
XT Modell
XL-X3 Modelsl
s
Figure 14. Replacing the Rear Shell
1
2
2
1
2
1