52
GasAlertMicroClip
Maintenance
• Press the front and rear shells together firmly to ensure a
proper seal. Ensure the front and rear shell have a uniform,
tight 1/16 in (1 mm) seal on all sides of the detector.
• When replacing the screws, they must be seated properly to
prevent cross threading. Turn the screw counter-clockwise until
a click is heard and then begin tightening the screw clockwise.
2. New sensors must be calibrated. Activate the detector an
d
ca
librate the sensor(s). Refer to Calibration
.
To Next Page
Loading...
