Apollo Hermes
command
available ?
cab Produkttechnik GmbH & Co KG 133
133
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX]
[ESC][i][L][S]
PRODUCT MARKING AND BARCODE IDENTIFICATION
H - Heat, Speed, Method of Printing, Ribbon
This command sets printing heat, speed and the method of printing for the current label.
Print quality is influenced by the used material and by the print heat and print speed.
H speed[,h][,t][,r]
CR
H = Heat / speed set parameter
speed = Print speed in millimeters or inches
These values depend on the printer type, please see the
operator´s manual for details. A "wrong value will automatically
rounded by the printer to the next possible value.
h = Heat setting (-10 up to +10)
t = Type: T=Transfer, D= Direct thermal (Default: T)
r = Ribbon saver on/off (Apollo 1 only) R0=off, R1=on
H 100,0,D,R1
Sets print speed to 100mm/s , Heat setting zero, Direct thermal mode and switches the ribbon saver
on. The ribbon saver is only available on Apollo 1 and Hermes. Apollo 2, 3 and 4 are not equipped
with a ribbon saver.
The maximum print speed depends on the used printer model. The print speed is automatically set to
the maximum if accidentially a higher printspeed is transmitted.
Example:
see Text x
To Next Page
Loading...
