Apollo Hermes
command
available ?
64 cab Produkttechnik GmbH & Co KG
64
PRODUCT MARKING AND BARCODE IDENTIFICATION
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX][ESC][i][L][S]
A - Amount of Labels
The A command is used to define the end of the label definition and it sets the amount of labels to be
printed. The printer repeats internally the defined label where the amount is defined by this command.
The label will stay in the printer´s internal buffer, after it has been sent to the printer.
sending the A command multiple times afterwards will print the amount of labels which is specified by
the A command.
A n
CR
n = amount of labels
Multiple options are available:
[NOPRINT] = receives and processes the label, but suppresses a printout.
(Used for saving a label on memorycard)
It is also possible to key in [NO] instead of [NOPRINT]
[?] = printer prompts on its display for the quantity or is also used to
be replaced from any attached system
[REPEAT] = Repeats the label at the end (makes only sense together with
the [?]option.
It is also possible to use [R] instead of [REPEAT]
[$DBF] = Prints each record of a database. Number of records = number
of labels.
J
S l1;0,0,68,71,100
T 25,10,0,5,8;LABEL PRINTER
A 550
prints 550 labels with the text line: "LABEL PRINTER"
J
S l1;0,0,68,71,100
T 25,10,0,5,8;LABEL PRINTER
A
Special function: Transmitting "A" without parameter causes the printer to print a infinite
number of labels.
Don´t forget the "carriage return" after the last command in the label !
Syntax:
Example:
Example:
xx
To Next Page
Loading...
Need help?
General
