CAB Apollo Series - C - Direct Cut

Apollo Hermes
command
available ?
42 cab Produkttechnik GmbH & Co KG
42
PRODUCT MARKING AND BARCODE IDENTIFICATION
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX][ESC][i][L][S]
c - Direct cut
The c ommand forces the printer to cut immediately when it is received.
If required, the printer will do formfeed before the cut is processed.
This command is not available for the Hermes - Series.
c CR
The printer shows "Protocol error" on the display when no cutter is attached.
Syntax:
x-