CAB Apollo Series - ESC* Activate All RS-485 Printers

Apollo Hermes
command
available ?
26 cab Produkttechnik GmbH & Co KG
26
PRODUCT MARKING AND BARCODE IDENTIFICATION
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX][ESC][i][L][S]
ESC* Activate all RS-485 printers
activates all printers in a RS-485 network
ESC*
Note: All printers have to be setup with the correct RS-485 network ID. This can be done with the
printer´s control panel (see operator´s manual).
This command can only be used in a RS-485 network ! Each network ID must be unique, otherwise
data crash will be the result. A maximum of 26 printers is allowed in a RS-485 network.
Valid RS-485 network adresses are A...Z
Syntax:
xx