Apollo Hermes
command
available ?
146 cab Produkttechnik GmbH & Co KG
146
PRODUCT MARKING AND BARCODE IDENTIFICATION
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX][ESC][i][L][S]
P - Set Peel-Off Mode
This command needs an optional peel off sensor, which varies from printer type to printer type.
This command pauses the printer after each label. The next label prints, when the actual label is
removed.
P[disp]
CR
P = Peel-Off Mode command.
disp = displacement in millimeters or inches (optional parameter)
positive and negative values can be used, depending in which
direction the displacement should work.
The "P" command needs to be placed after the definition of the page size ! ("S"- command)
Syntax:
xx
To Next Page
Loading...
