Apollo Hermes
command
available ?
136 cab Produkttechnik GmbH & Co KG
136
PRODUCT MARKING AND BARCODE IDENTIFICATION
[TABLE OF CONTENTS]
[COMMAND LIST][INDEX][ESC][i][L][S]
J - Job Start
The J command "tells " the printer, that the following data contains label specific data. It starts a new
print job.
J [comment]
CR
J = Job start command.
comment = Optional text which may describe the label.
This optional text will be displayed on the printers LC Display when it
is recalled from the optional memory card. Maximum length is 16
characters.
J Adress label
Defines the job start and names the label " Adress Label".
Adress Label will be displayed in the printer´s LC Display when the label is recalled from the optional
memory card. The printer "looks" into each label on the memory card and controls if an alternative
Label description is available. This description is shown instead of the original label name which is
limited to 8 characters.
Example:
Syntax:
xx
To Next Page
Loading...
Need help?
General
