● A PIN code is generated.
From a Computer
8
Register the generated PIN code to the wireless router.
● Register the PIN code on the setup screen displayed in step 1.
● The PIN code must be registered within 10 minutes after pressing in step 7.
If an error message is displayed during setup
Press and return to step 6.
From the Operation Panel
9
Check that the Wi-Fi indicator is blinking on the operation panel.
● The Wi-Fi indicator blinks when a wireless router is detected.
● When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi
indicator lights up.
● Wait approximately 2 minutes until the IP address settings of the machine are completed.
Signal strength
When more than one wireless router is available for connection, the machine connects to the device with the
strongest signal. Signal strength is measured using RSSI (Received Signal Strength Indication).
Network
168
To Next Page
Loading...
