Canon imageCLASS D570 - Specifying IP Addresses for Firewall Rules

Specifying IP Addresses for Firewall Rules
19Y4-04J
You can either limit communication to only devices with specied IP addresses, or block devices with specied IP
addresses but permit other communications. You can specify a single IP address or a range of IP addresses.
● Up to 4 IP addresses (or ranges of IP addresses) can be specied for both IPv4 and IPv6.
● The packet lters described in this section control communications over TCP, UDP, and ICMP.
1
Start the Remote UI and log on in System Manager Mode. Starting Remote
UI(P. 266)
2
Click [Settings/Registration].
3
Click [Security Settings] [IP Address Filter].
4
Click [Edit] for the lter type that you want to use.
Security
227