Important
•
Keeping a roll in the printer for a long time without printing on it may leave a depression on the leading edge.
When printing quality is most important, we recommend setting TrimEdge Reload to On or Automatic so that
the paper edge is automatically cut before printing.
•
Before printing banners or other long documents, tap the Output Stacker. We recommend that you spread a
clean cloth or paper on the floor and select Eject as the cutting method for rolls to prevent the printed surface
from becoming dirty or scratched. (See "Specifying the Cutting Method for Rolls.") ➔P.376
Note
•
For details on supported sizes and types of rolls, see Paper Sizes or the Paper Reference Guide. (See "Paper
Sizes.") ➔P.352 (See "Types of Paper.") ➔ P.352
•
To wait until the ink dries after printing before cutting the roll, set Drying Time in the printer driver. (See "Specify-
ing the Ink Drying Time for Rolls.") ➔P.374
•
Once you have used all the paper on a roll, clean the platen. If the Platen inside the Top Cover becomes dirty, it
may soil the underside of paper. (See "Cleaning Inside the Top Cover.") ➔P.592
1
Turn the printer on. (See "Turning the Printer On and Off.") ➔P.17
2
Load the roll on the Roll Holder. (See "Loading Rolls
on the Roll Holder.") ➔P.363
iPF6400SE
Loading and Printing on Rolls
User's Guide
Basic Printing Workflow Printing procedure
19
To Next Page
Loading...
Need help?
General