Cause Corrective Action
The NetWare server and serv-
ices are not configured correctly.
2.
Make sure there is enough free disk space on the NetWare file server. Insufficient disk space may
prevent you from processing large print jobs.
3.
Start NWADMIN or PCONSOLE and confirm that the print service is configured correctly and the
print queue is available.
4.
If data transmission to a printer on another subnet fails, deactivate NCP burst mode in that print-
er's network protocol settings.
5.
If the printer is used in queue server mode, specify Other/Unknown as the printer type.
The printer was turned off and
on when not disconnected from
the server.
Leave the printer off for at least 30 seconds, and then restore power.
Cannot print over AppleTalk or Bonjour networks
Cannot print over AppleTalk or Bonjour networks
Cause Corrective Action
The AppleTalk protocol is not ena-
bled on the printer.
Activate AppleTalk on the printer.
(See "Configuring the Printer's AppleTalk Network Settings.") ➔P.523
The computer you are trying to
print from is not configured cor-
rectly.
Make sure the computer's AppleTalk settings are configured correctly.
(See "Configuring the Destination for AppleTalk Networks (Mac OS).") ➔P.521
(See "Configuring the Destination for Bonjour Network (Mac OS).") ➔P.521
The computer and printer are not
on the same network.
Due to the nature of Bonjour, you cannot print if the printer is on another network behind a router.
Make sure the computer and printer are on the same network. For information about network set-
tings, ask your network administrator.
Cannot print over AppleTalk or Bonjour networks
iPF6400SE
User's Guide
Troubleshooting Cannot print over a network
632