Memory
Memory 256 MB
Interface
Hi-Speed USB Format Internal port
Mode Full-speed (12 Mbps), high-speed (480 Mbps), bulk transfer
Connector Series B (4-pin)
Ethernet Format Internal port
Specification IEEE 802.3 10Base-T,
IEEE 802.3u 100Base-TX/Auto-Negotiation,
IEEE 802.3x Full Duplex
Protocols IPX/SPX (Netware 4.2, 5.1, 6.0), SNMP (Canon-MIB compatible),
HTTP, TCP/IP (IPv4/IPv6), AppleTalk
Ink
For information on the ink the printer supports, see "Ink Tanks." ➔P.568
Paper
For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See "Displaying the
Paper Reference Guide.")
➔P.356
Paper width For information on the paper widths the printer supports, see "Paper Sizes." âž” P.352
Minimum paper length Rolls 203.2 mm (8.0 in)
Sheets Top Paper Feed Slot 279.4 mm (11.0 in)
Maximum printable
length (*1)
Rolls 18 m (19.7 yd)
Sheets Top Paper Feed Slot 1,600 mm (63.0 in)
Thickness Rolls 0.07–0.8 mm (0.0028–0.031 in)
Sheets Top Paper Feed Slot 0.07–0.8 mm (0.0028–0.031 in)
Roll maximum outer diameter 150 mm (6 in) or shorter
Supported paper core inner diameter 2 inches / 3 inches
Print area For details, see "Print Area." ➔P.661
*1: Varies depending on the operating system or application.
Print Area
Print Area
A margin required by the printer is added with respect to the size of paper loaded in the printer. Except in borderless
printing, the actual printing area corresponds to the paper size minus the space for this margin.
Printable Area Recommended Print Area
Top Edge Bottom Edge Sides Top Edge Bottom Edge Sides
Sheets 3 mm (0.12 in) 3 mm (0.12 in) 3 mm (0.12 in) 20 mm (0.79 in) 23 mm (0.91 in) 5 mm (0.20 in)
Rolls 0 or 3 mm (0 or 0.12
in)
0 or 3 mm (0 or 0.12
in)
0 or 3 mm (0 or 0.12
in)
20 mm (0.79 in) 5 mm (0.20 in) 5 mm (0.20 in)
iPF6400SE
Print Area
User's Guide
Specifications Printer Specifications
661