Important
•
Do not touch the Linear Scale (a) or Carriage Shaft (b).
This may stain your hands and damage the printer.
Note
•
Here, the Belt Stopper is the one that was removed and stored after initial installation.
4
Close the Top Cover.
5
If any options are attached to the printer, remove them from the printer and pack them.
6
Tape down printer covers to secure them, in the reverse or-
der of tape removal during installation.
7
Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a shipping
box.
Reinstalling the Printer
Reinstalling the Printer
The basic workflow for reinstalling the printer is as follows.
For detailed instructions, see the Setup Guide.
Reinstalling the Printer
iPF6400SE
User's Guide
Maintenance and Consumables Other Maintenance
604
To Next Page
Loading...
Need help?
General