Setting Item Description, Instructions
Interface
Setup
NetWare
Print Service Choose the print service.
AppleTalk Specify whether to use the AppleTalk protocol. To apply
your changes, choose Register Setting.
Ethernet
Driver
Auto Detect Specify the communication method. To apply your changes,
choose Register Setting.
Choose On for automatic configuration of the LAN commu-
nication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Comm.Mode Choose the LAN communication method.
Ethernet Type Choose the LAN transfer rate.
Spanning Tree Choose whether spanning-tree packets are supported over
the LAN.
MAC Address Indicates the MAC address.
Interface Print Print interface settings information.
Return Defaults Choose OK to restore Interface Setup settings to the de-
fault values.
System
Setup
Sleep Timer Specify the period before the printer enters sleep mode.
Shut Down Timer Sets the time until the printer turns off automatically. If no
operations are performed on the printer for the duration of
the time set in Shut Down Timer after entering Sleep
mode, the printer automatically turns off.
Buzzer Choose On for the buzzer to sound once for warnings and
three times for errors.
Contrast Adj. Adjust the Display Screen contrast level.
Date &
Time
Date Set the current date.
Time Set the current time. Available only if the Date setting is
specified.
Date Format Specify the date format.
Language Specify the language used on the Display Screen.
Time Zone Specify the time zone. Time zone options indicate a main
city in this time zone and the difference from Greenwich
Mean Time.
Length Unit Choose the display unit for length. Change the unit dis-
played for the remaining amount of roll paper, Tot.Print
Area, and so on.
Detect Mismatch Specify printing behavior if the type and size of paper speci-
fied in the printer menu does not match the type and size in
the printer driver.
Choose Pause to have printing paused under these circum-
stances. Choose Warning to continue printing after notifica-
tion. Choose None to continue printing without notification.
Paper
Size Ba-
sis
Roll Selection 1 If roll size detection is activated, choose whether ISO A3
(297mm) or 300mm Roll is applied when a roll of an inter-
mediate width is detected.
Roll Selection 2 If roll size detection is activated, choose whether 10in.
(254mm) or JIS B4 (257mm) is applied when a roll of an
intermediate width is detected.
Menu Settings
iPF6400SE
User's Guide
Control Panel Printer Menu
480
To Next Page
Loading...
Need help?
General