6
Select the print target in the E Print Target list.
Important
•
When you are using paper that takes longer for ink to adhere for borderless printing and the Cutter Unit
touches printing surfaces that are not dry yet, it may damage the paper or the edge of the document that is
cut, depending on frequency of use. In this kind of situation, change the ink drying time using the following
procedure.
•
Click Advanced Settings in Media Type.
•
Select an ink drying time in the list for the Between Pages setting of Drying Time.
7
Click the Page Setup tab to display the Page Setup
sheet.
8
In the A Page Size list, click the size of the original as specified in the source application. In this case, click
10"x12".
9
Select and click a roll paper in the L Paper Source list.
10
Select the B Borderless Printing check box to display
the Information dialog box.
11
Select the width of the loaded roll in the Roll Paper Width list—in this case, click 10-in. Roll (254.0mm).
12
Click OK to close the Information dialog box.
iPF6400SE
Borderless Printing at Actual Size (Windows)
User's Guide
Enhanced Printing Options Printing at full size
73
To Next Page
Loading...
Need help?
General