Canon imagePROGRAF IPF700 - Applying the Grease

Chapter 4
4-28
4.4 Applying the Grease
4.4.1 Applying The Grease
0013-9975
Apply the grease at the location shown below.
Smear the grease lightly and evenly with a flat brush.
Don't apply the grease to locations other than those designated. Unwanted grease may cause poor print quality,
take particular care that grease does not get onto the wiper, cap, or the linear scale.
F-4-39
F-4-40
Cam : Permalub G No.2
approx. 12mg
Plate spring : Permalub G No.2
approx. 12mg
Lock pin :
Permalub G No.2 approx. 12mg
Joint :
Molykote PG-641 approx. 24mg
Permalube G No.2
approx. 24mg