Chapter 6
6-14
6.1.4.26 03810201-2581/03810202-2582/03810203-2583/03810204-2580/03810206-
2586/03810206-2587 Tank level error 1
0013-6847
<Cause>
When head cleaning was executed automatically at ink level 1, insufficiency of ink was detected.
Opening the ink tank cover recovers this error. The error recovery operation is continued until it is cancelled
using the STOP key.
<Probable fault location>
Ink tank, ink tank unit, or main controller PCB
<Countermeasure>
1) Replace the ink tank.
2) Cable continuity check
If continuity of the cable between the ink tank and the main controller PCB is abnormal, replace the cable.
3) Replace the ink tank unit.
4) Replace the main controller PCB.
6.1.4.27 03810201-2591/03810202-2592/03810203-2593/03810204-2590/03810206-
2596/03810206-2597 Tank level error 2
0013-6848
<Cause>
When head cleaning was executed by the user at ink level 1, insufficiency of ink was detected.
Opening the ink tank cover recovers this error. The error recovery operation is continued until it is cancelled
using the STOP key.
<Probable fault location>
Ink tank, ink tank unit, or main controller PCB
<Countermeasure>
1) Replace the ink tank.
2) Cable continuity check
If continuity of the cable between the ink tank unit and the main controller PCB is abnormal, replace the cable.
3) Replace the ink tank unit.
4) Replace the main controller PCB.
6.1.4.28 03830101-2521/03830102-2522/03830103-2523/03830104-2520/03830106-
2526/03830105-2527 Ink tank is not installed. ( This error occurs when the ink tank is
replaced.)
0013-6840
<Cause>
When the ink tank was replaced, the closed state of the ink cover was detected with the ink tank removed.
<Probable fault location>
Operation method, ink tank, ink tank cover switch, ink tank unit, or main controller PCB
<Countermeasure>
1) Operation check
To Next Page
Loading...
Need help?
General
