Canon imagePROGRAF IPF700 Service Manual

Chapter 6
6-18
<Probable fault location>
Ink tank, tube unit, or main controller PCB
<Countermeasure>
1) Replace the ink tank unit and tube unit.
After replacing the ink tank and tube unit, select [SERVICE MODE]>[INITIALIZE]>[PARTS COUNTER] to
reset the counter.
2) Replace the main controller PCB.
6.1.5.3 E146-4001 Borderless/idle ejection/mist collection count full
0013-8108
<Cause>
The machine detected that the waste ink box or the mist fan unit became full of ink.
<Probable fault location>
Waste ink box, mist fan unit, or main controller PCB
<Countermeasure>
1) Replace the waste ink box or mist fan unit.
After replacing the waste ink box or mist fan unit, select [SERVICE MODE]>[INITIALIZE]>[PARTS
COUNTER] to reset the counter.
2) Replace the main controller PCB.
6.1.5.4 E161-403E Abnormally high head temperature
0013-7245
<Cause>
The printhead temperature became abnormally high.
<Probable fault location>
Printhead, head relay PCB, carriage relay PCB, or main controller PCB
<Countermeasure>
1) Start up the printer in the service mode, and then replace the printhead.
2) Replace the head relay PCB.
3) Replace the carriage PCB.
4) Replace the main controller PCB.
6.1.5.5 E194-404A Non-discharge detection count error
0014-1073
<Cause>
The machine detected that the non-discharge count reached the specified value.
<Probable fault location>
Head management sensor or main controller PCB
<Countermeasure>
1) Replace the head management sensor.
After replacing the head management sensor, select [SERVICE MODE]>[INITIALIZE]>[PARTS COUNTER]
to reset the counter.
2) Replace the main controller PCB.
6.1.5.6 E196-4040/E196-4041/E196-4042/E196-4043/E196-4044/E196-4045 Main
controller PCB error
0014-1079
<Cause>
The main controller PCB is defective.
<Probable fault location>

Canon imagePROGRAF IPF700 Specifications

General

Brand	Canon
Model	imagePROGRAF IPF700
Category	Printer
Language	English