Canon imagePROGRAF IPF700 Service Manual

Chapter 7
7-1
7.1 Service Mode
7.1.1 Service Mode
0013-7777
a. How to enter the Service mode
Enter the Service mode following the procedure below.
(1) Turn off the printer.
(2) Turn on the printer while holding down the [Paper Source]key and [Informarion]key.
*Keep pressing the above buttons until "Initializing"appears on the display.
(3) "S" is displayed in the upper right corner of the display showing the version.
(4) After display of "Online",pressing the [Menu]key displays the SERVICE MODE top menu and the
MESSAGE LED flashies.
*The Service mode is added to the options in the Main menu. The Service mode can be entered even in the error
status(when an error message is shown on the display)by turning the power off and then using the above key
operation.
b. How to exit the Service mode
Turn off the printer.
c. Key operation in the service mode
-Selecting menus and paremeters:[ ] or [ ] key
-Going to the next lower-level menu:[ ] key
-Going to the next higher-level menu:[ ] key
-Determining a selected menu or parameter:[OK] key

Canon imagePROGRAF IPF700 Specifications

General

Brand	Canon
Model	imagePROGRAF IPF700
Category	Printer
Language	English