Changing the Type of Paper
Note
• When you load a roll, a menu for selection of the type of paper is shown on the Display Screen. Select the type of paper, and
then press the OK button.
If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the roll length after the type of
paper.
(See "Specifying the Paper Length.")
→
P.545
1
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to se-
lect the Paper tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Paper Menu is displayed.
3
Press â–² or â–¼ to select Chg. Paper Type, and then press the OK button.
4
Press â–² or â–¼ to select the type of paper loaded ( Roll Paper or Cut Sheet ), and then press the OK button.
5
Press â–² or â–¼ to select the type of paper loaded in the printer, and then press the OK button.
Important
• Be sure to select the correct paper type. If this setting does not match the loaded paper, it may cause feed errors
and affect printing quality.
Note
• For details on types of paper, see the Paper Reference Guide. (See "Types of Paper.")
→
P.528 By default, Plain
Paper is selected.
• If you move the Release Lever, the setting automatically reverts to the previously selected paper.
Using the Same Type of Paper Regularly
Configure this setting so that current media type settings will be automatically selected when you load the same type of
paper later.
1
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to se-
lect the Paper tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Paper Menu is displayed.
Changing the Type of Paper
iPF8400
User's Guide
Handling and Use of Paper Handling rolls
544
To Next Page
Loading...
Need help?
General
