6
Press â–² or â–¼ to select the desired setting option, and then press the OK button.
This setting takes effect the next time you load a roll.
Reducing Dust from Cutting Rolls
Reducing Dust from Cutting Rolls
For media such as Backlit Film that are more likely to generate debris when cut, select CutDustReduct. > On in the
Paper Menu of the Control Panel. This option reduces debris from cutting by printing black lines at the leading and
trailing edges of documents. It may help prevent Printhead damage. You can specify for CutDustReduct. to be activa-
ted for particular types of paper.
Important
• Do not set CutDustReduct. to On for paper that wrinkles easily, such as Plain Paper or lightweight paper. This may impair
cutting and cause paper jams.
• Borderless printing is not available when CutDustReduct. is set to On. To use borderless printing, select CutDustReduct. >
Off.
Set CutDustReduct. to On as follows.
1
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to se-
lect the Paper tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Paper Menu is displayed.
3
Press â–² or â–¼ to select Paper Details, and then press the OK button.
4
Press â–² or â–¼ to select the type of paper loaded in the printer, and then press the OK button.
5
Press â–² or â–¼ to select CutDustReduct., and then press the OK button.
6
Press â–² or â–¼ to select On, and then press the OK button.
Reducing Dust from Cutting Rolls
iPF8400
User's Guide
Handling and Use of Paper Handling rolls
560
To Next Page
Loading...
Need help?
General
