Canon imagePROGRAF iPF8400 User Manual

Cutter Unit
Cutter Unit
Cutter Unit ............................................................................................................................................................................... 930
Replacing the Cutter Unit .................................................................................................................................................. 930
Cutter Unit
Cutter Unit
When purchasing, check the Model number.
Shape Model number
CT-06
Note
• For instructions on Cutter Unit replacement, see "Replacing the Cutter Unit."
→
P.930
Replacing the Cutter Unit
Replacing the Cutter Unit
Compatible Cutter Units
For information on compatible cutter units, see "Cutter Unit."
→
P.930
Access the menu for cutter unit replacement
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Settings/Adj. tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2 Press the OK button.
The Set./Adj. Menu is displayed.
3 Press ▲ or ▼ to select Maintenance, and then press the OK button.
4 Press ▲ or ▼ to select Change Cutter, and then press the OK button.
The Carriage moves. When it finishes moving, instructions are displayed on the Display Screen.
Note
• If you do not respond within two minutes, cutter cleaner replacement is canceled. In this case, repeat the procedure.
Cutter Unit iPF8400
User's Guide
Maintenance and Consumables Cutter Unit
930

Canon imagePROGRAF iPF8400 Specifications

General

Internal storage capacity	250 GB