Problems Regarding Paper
Problems Regarding Paper
Clearing Jammed Roll Paper ............................................................................................................................................ 958
Clearing a Jammed Sheet .................................................................................................................................................. 961
Roll paper cannot be inserted into the paper feed slot ....................................................................................... 964
Cannot load sheets ............................................................................................................................................................... 964
Paper is not cut straight .................................................................................................................................................... 965
Paper is not cut ...................................................................................................................................................................... 965
The media take-up unit continues rotating ................................................................................................................ 965
The size of clear film cannot be detected .................................................................................................................. 966
Margins are wide ................................................................................................................................................................... 966
When printing on thin roll paper, the printed surface becomes scratched ................................................ 966
Clearing Jammed Roll Paper
Clearing Jammed Roll Paper
If roll paper jams, follow the steps below to remove jams.
1
Turn the printer off. (See "Turning the Printer On and Off.")
→
P.23
2
Open the Top Cover.
Note
• If the leading edge of the roll jams in the carriage such as when the paper curls strongly, you may be able to avoid
paper jamming by setting the roll cutting method to Manual and setting the detection of paper leading edge to [Off].
(See "Specifying the Cutting Method for Rolls.")
→
P.552
3
If the Carriage is out, move the Carriage out of the way,
away from the paper.
Caution
• If you push the Carriage to the left edge, the blade of the Cutter Unit will be lowered in preparation to cut the paper.
Be careful not to pinch your fingers between the Carriage and Platen if you have pushed the Carriage to the left
edge or if a paper jam occurs during cutting.
Clearing Jammed Roll Paper
iPF8400
User's Guide
Troubleshooting Problems Regarding Paper
958
To Next Page
Loading...
