Printing Interface Print reports
1
Load the paper.
If using sheets, load paper A4/Letter-sized, you will need at least three sheets.
2
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to se-
lect the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
3
Press the
OK button.
The Set./Adj. Menu is displayed.
4
Press â–² or â–¼ to select Test Print, and then press the OK button.
5
Press â–² or â–¼ to select Interface Print, and then press the OK button.
Confirming Interface Print information
The following information is included in the Interface Print report.
Canon imagePROGRAF iPFxxxx Interface Print Printer model
Firm Firmware Version
Boot Boot ROM Version
MIT(DBF) MIT Database Format Version
MIT(DB) MIT Database Version
S/N Printer serial number
Date The date when the interface setup print report was
printed.
EOP Timer Specify the timeout period before cancellation of print
jobs that cannot be received by the printer.
TCP/IPv4 Frame Type IPv4 settings values.
Use DHCP
Use BOOTP
Use RARP
Enable DNS Dynamic Update
Use Zeroconf Function
IP Address
Subnet Mask
Gateway Address
LPD Printing
Printing Interface Setting Reports
iPF8400
User's Guide
Control Panel Printer Menu
686
To Next Page
Loading...
Need help?
General
