Important
• Before specifying the frame type, make sure the printer is on and connected to the network.
Note
• You can specify the frame type by using RemoteUI if the printer's IP address is configured.
• For instructions on installing imagePROGRAF Device Setup Utility, see "Installing imagePROGRAF Device Setup Utility."
→
P.736 .
Specifying the frame type using imagePROGRAF Device Setup Utility
1
Start imagePROGRAF Device Setup Utility.
2
In the list of printers, select the printer to configure.
3
Choose Protocol Settings from the Printer menu.
4
Click the NetWare tab and select the frame type in the
NetWare Frame Type list.
iPF8400
Specifying the Printer's Frame Type
User's Guide
Network Setting NetWare Settings
719
To Next Page
Loading...
