Printing Hanging and Horizontal Banners (Large-Format
Printing)
A drapery or banner can be made by enlarging or reducing original documents made on application
software.
The procedure for printing hanging and horizontal banners is as follows:
Print for width of roll
1.
Create document by using application software
1.
2.
Open the printer driver setup window
2.
3.
Select the paper size
3.
Select the same original paper size created in the application soft in the Page Size on the Page Setup
tab.
In the event an optional size is set in the application software, select Custom Size from Custom
Paper Size in Page Size and designate size in the dialog box that appears.
4.
Select roll width
4.
Select the equivalent to the paper width of the roll set in the printer under Roll Paper Width.
5. Set Enlarged/Reduced Printing5.
Check Enlarged/Reduced Printing and select Fit Roll Paper Width.
When the Information dialog box appears, select the equivalent to the paper width of the roll set in
the printer.
152
To Next Page
Loading...
Need help?
General
Weight and Dimensions
