By using the barcode every time you replace a roll, you can manage remaining roll amount properly.
Specify the roll length properly when you load a new roll.
◦ Auto estimate◦
Estimates and manages the remaining amount of roll paper.
The estimated remaining roll amount is displayed on the HOME screen.
The barcode is not printed when Auto estimate is selected.
To estimate the remaining roll amount, Paper thickness and Paper core outer diameter have to
be set correctly.
When using a paper that is not listed in the paper information list, set Thickness and Paper Tube
Size in Advanced paper settings or in Media Configuration Tool.
For paper thickness and paper tube outer diameter size, contact the paper manufacturer.
Important
• If you do not select the media type correctly, the remaining roll amount may not be estimated•
correctly.
• There is an error in the estimated remaining roll amount, and paper may run out during printing.•
◦ Disable◦
Select to disable managing remaining roll amount.
• Roll amount warning settings•
Specifies when to warn the remaining roll paper amount.
• Detect paper setting mismatch•
Selects printer action when you start printing with the paper size, the media type, and print settings
different from those registered.
• Advanced paper settings•
Specifies advanced paper settings for each paper type.
• Paper size recognition settings•
Selects which size is preferred when paper size detection is enabled.
◦ Roll paper setting 1◦
Select whether B4 or 10 inch is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 2◦
Select whether A3 or 300 mm is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 3◦
Select whether 300 mm or 12 inch is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 4◦
Select whether 500 mm or 20 inch is applied when a roll of an intermediate size is detected.
◦ Roll paper setting 5◦
357
To Next Page
Loading...
Need help?
General
Weight and Dimensions
