To set / change the password for sending in order to perform the authentication, check the
Set/change password and then enter the password.
• POP before SMTP•
Select if you send e-mail with POP before SMTP authentication.
Next, you can specify the following settings.
◦ Incoming mail server (POP3)◦
Enter the address of your POP server.
◦ Port number (POP3)
◦
Enter the port number of your POP server.
◦
Incoming account
◦
Enter the account name for receiving to perform the authentication.
◦
Incoming password
◦
To set / change the password for receiving in order to perform the authentication, check the
Set/change password and then enter the password.
•
Use APOP authentication
•
Select if you send the password by the encryption transmission.
• Clear mailbox•
Select if you delete the e-mails that remain in the POP3 server.
Important
• When this setting is enabled, e-mail in the Inbox on the server will have all been removed.•
If you specify the e-mail address of your everyday, be sure to disable this setting as unread
e-mail is not deleted. We recommend that you prepare this printer dedicated e-mail account
not to accidentally delete the unread e-mail.
5. No authentication5.
Select if the authentication is not necessary.
6. Select OK.6.
The setting operation is completed.
473
To Next Page
Loading...
