Canon LaserBase MF5600 - Removing the Board Unit; Removing the NCU Board; Removing the NCU Case; Removing the Scanner Unit

Chapter 3
3-44
3.1.20.7 Removing the NCU
Case
0006-3762
1) Remove the three screws [1]; then, pull the upper
portion of the NCU case [2] toward you, and lifting
it upward, remove the NUC case.
F-3-189
3.1.20.8 Removing the Scanner
Unit
0006-3763
1) Remove the screw [1] and remove the connector [2]
as well as the flat cable [3] on the DCNT board.
Remove the tape holding the cable in advance.
Prepare a new tape (Part No: AZ7-0008) of a suitable
length before you attach the cable again.
F-3-190
2) Remove the two front screws [1].
F-3-191
3) Remove the two screws on the back [1]. Slide the
scanner unit [2] to the back; then, remove it by
lifting it.
F-3-192
3.1.20.9 Removing the Board
Unit
0006-3765
1) Remove the four screws [1] on the back side of the
scanner unit. Ensure that the mounting plate [2]
does not get lost.
F-3-193
[1]
[2]
[2] [1]
[3]
[1]
[2]
[1]
[1]
[2]